Blocking in Wound Roll After Water-based Ink Printing
Blocking (also called set-off) happens when the printed surface sticks to the back of the web after rewinding. For water-based ink lines, the leading cause is residual moisture trapped inside the ink layer. This guide isolates blocking causes and fixes them on press.
Typical failure phenomena
- Print transfers to the back of the web on unwinding
- Inner layers of the roll show gloss loss
- Problem is worse in summer / humid weather
- Blocking worsens toward roll center (tightest tension)
Root-cause checklist (in priority order)
1. Residual moisture in ink layer
- Incomplete drying leaves 3-6% water in the ink film. This plasticizes the binder and causes set-off.
- Confirm web temperature at dryer exit reaches 65°C.
2. Rewind tension
- Too high rewind pressure squeezes ink layers together. Tension should be set lower than for solvent runs.
- Taper tension toward roll center to reduce inner-layer pressure.
3. Ambient humidity & storage
- Water-based printed rolls should cool to room temperature before packing. Hot rolls trap moisture inside.
- Store rolls below 60% RH; do not stack them directly on concrete floors.
4. Ink binder softening
- If blocking persists after drying, the binder Tg may be too low for the line speed. Discuss with supplier for a higher-Tg grade.
Practical step-by-step solutions
- Verify web exit temperature ≥ 65°C; raise oven if needed.
- Lower rewind tension and use taper tension toward the core.
- Cool rolls 30 minutes on a cooling rack before packing.
- Store at 20-25°C, below 60% RH, away from exterior walls.
- If blocking continues, switch to a higher-Tg / faster-setting ink grade.
Need technical support or sample?
Send your substrate specification, machine parameters and failure photos. Our application engineer in Hangzhou will reply with a targeted recommendation and lab sample.
Send technical inquiry Request sampleFrequently asked questions
Why is blocking worse with water-based ink than solvent ink?
Water evaporates slower than solvent. If drying is under-tuned, residual moisture softens the binder and the roll sets off.
Can I fix blocking by adding wax?
Wax improves surface slip but does not replace proper drying. Combine wax with better oven airflow.
How long should rolls rest before conversion?
Allow 24-48 hours at controlled humidity before lamination or sheeting.