How to Improve Ink Adhesion on PET Film
When water-based gravure or flexo ink peels off PET (polyester) film after tape test or rub, the root cause is rarely the ink alone. It is usually a combination of surface-energy decay, film contamination, wrong binder resin and incomplete drying. This guide helps printing-plant engineers isolate and fix the issue in priority order.
Typical failure phenomena
- 3M tape test peels ink cleanly off the web
- Ink rubs off under light friction after full drying
- Adhesion is good at roll start but fails toward roll end
- Adhesion collapses after heat lamination or heat-sealing
Root-cause checklist (in priority order)
1. Corona treatment & surface-energy decay
- Untreated PET sits at 38-42 mN/m; water-based ink needs 48-52 mN/m to anchor.
- Test incoming film with a dyne pen before printing; reject rolls below 48 mN/m.
- Corona effect decays over time. Do not print corona-treated PET older than 48-72 hours.
- Verify electrode gap, power setting and web speed; uneven corona causes banded adhesion across the web width.
2. Surface contamination on PET substrate
- Silicone release agents, anti-block masterbatch, slitter oil and dust create a barrier layer.
- Avoid PET grades with heavy anti-block additive for direct water-ink printing.
- Wipe a sample strip with isopropyl alcohol and re-run the tape test — a big improvement points to contamination.
3. Binder resin & ink grade mismatch
- Decorative-paper general-purpose ink is not formulated for bare PET. Use a PET-oriented acrylic / polyurethane binder system.
- Over-diluting ink with water lowers binder concentration and weakens final adhesion.
- Confirm the ink TDS explicitly names corona-treated polyester as a substrate.
4. Drying tunnel & residual moisture
- Water-based ink must reach a web temperature of at least 65°C to fully evaporate.
- High-speed gravure lines often under-dry even when oven setpoints look normal.
- Raise air velocity before raising temperature; moisture trapped inside the ink layer ruins adhesion and lamination.
Practical step-by-step solutions
- Measure dyne value on every incoming roll; re-corona if it has decayed below 48 mN/m.
- Print corona-treated PET within 48 hours of treatment.
- Switch to a water-based ink grade designed for corona-treated polyester.
- Hold ink viscosity in the supplier-recommended range; do not over-dilute.
- Optimize oven temperature and air flow so the web reaches 65°C before rewinding.
- Run tape-test and rub-resistance checks at start, mid-roll and end-of-roll.
Need technical support or sample?
Send your substrate specification, machine parameters and failure photos. Our application engineer in Hangzhou will reply with a targeted recommendation and lab sample.
Send technical inquiry Request sampleFrequently asked questions
Most often the film surface energy is below 48 mN/m, the corona treatment has decayed, or a general-purpose paper ink was used on polyester substrate.
No. Decorative-paper ink uses binders optimized for absorbent paper. Bare PET needs a special polyester-oriented acrylic/polyurethane system.
Every incoming roll, and again at start-up after any corona-system maintenance.