Pinholes & Haze on Decorative Paper Gravure Printing

By Hywelt Technical Team · Published 2026-11-04 · Reading time ~5 min

Decorative paper printing demands near-perfect solid blocks — any pinhole or haze shows up under melamine resin impregnation. This guide isolates the typical causes and the order in which engineers should check them.

Typical failure phenomena

Root-cause checklist (in priority order)

1. Paper absorbency & sizing

2. Cylinder & cell damage

3. Ink drying too fast

4. Dust & airborne contamination

Practical step-by-step solutions

  1. Compare defects across paper batches; switch supplier if isolated to one batch.
  2. Inspect cylinder cells under 10x magnification; re-chrome if damaged.
  3. Reduce print-station oven temperature and adjust co-solvent level.
  4. Install web cleaner and air ionizer before the print cylinder.
  5. Filter ink through 80-100 micron mesh before filling the fountain.

Need technical support or sample?

Send your substrate specification, machine parameters and failure photos. Our application engineer in Hangzhou will reply with a targeted recommendation and lab sample.

Send technical inquiry Request sample

Frequently asked questions

Why do pinholes appear only in dark colors?

Dark colors use higher pigment loading and lower binder-to-pigment ratio, so any small disruption shows more.

Is haze always an ink problem?

No. Haze often comes from paper over-sizing or cylinder damage, not ink.

How often should I inspect the cylinder?

At every color change and weekly for long runs.