Moving from Solvent-based to Water-based Inks and Coatings

Most solvent-to-water projects fail on drying, not on chemistry. Water carries a different evaporation profile, so a press that runs comfortably on solvent ink can be drying-limited on water-based at the same speed and film build.

The second most common failure is colour: shades that match on a drawdown do not necessarily match at production opacity and speed. Both issues are predictable, and both are cheap to test before a line is committed.

Where this application fails

How Hywelt approaches it

Products used in this application

ProductRange
Water-based Gravure Surface Printing InkWaterborne & Printing Inks
Water-based Gravure Ink for Shrink FilmWaterborne & Printing Inks
Water-based Ink for PVC Decorative FilmWaterborne & Printing Inks

What we need before quoting

Current systemSolvent ink type, line speed, film build, dryer configuration
SubstrateFilm or paper, treatment method and consistency
ConstraintsSpeed and quality that cannot be given up
ConversionDownstream steps the print must survive

Frequently Asked Questions

Can we keep our existing dryer?

Sometimes, at reduced speed. Drying capacity is measured at your line speed and film build during the trial, and the result states what the existing dryer actually achieves — rather than assuming it is sufficient.

How much colour drift should we expect?

Drift depends on opacity and film thickness at production speed. Colour is matched at production conditions during the trial, with a stated tolerance, so the comparison is like for like.

Is a partial switch practical?

A staged switch — one product family or one colour first — is the usual route. It limits exposure while the drying and handling questions are answered on real work.

Related pages

Contact Hywelt

Email: [email protected] (site inbox)
Overseas main: [email protected]
WhatsApp: +86 13216144789

Send substrate, process and end-use details for a quotation — response within 1 business day. English / Spanish / Russian support.