水性凹印油墨起泡与微泡缺陷
起泡是水性油墨上机最显眼的缺陷,会导致针孔、密度不均、刀丝和停机。本指南定位来源并列出工程师无需换墨即可执行的修复方法。
典型故障现象
- 墨槽液面堆积白色泡沫
- 印刷图文里 trapped 微泡
- 实色块出现针孔
- 泡沫体积增大时色密度下降
根因排查清单(按优先级)
1. 机械卷入空气
- Pump return line above the ink surface whips air in. Submerge the return pipe.
- Too-high pump circulation speed creates vortex; reduce flow.
- Leaking seals on the pump draw in air.
2. 油墨配方与消泡剂
- Defoamer drops off over time due to foam breaker consumption; top up at the recommended ratio.
- Do not over-add defoamer — it causes fisheyes and craters.
3. 基材润湿
- If the substrate is poorly wetted, ink recedes and leaves micro-pinholes. This is wetting failure, not foam.
- Add a small amount of wetting agent rather than extra defoamer.
4. 温度
- Warm ink (above 35°C) foams more easily. Cool the circulating ink tank.
分步解决方案
- 回液管浸入液面以下,消除旋涡
- 降低泵循环速度
- 按推荐比例补加消泡剂,勿过量
- 夏季墨槽冷却至20-30℃
- 若针孔仍存在,转查基材润湿问题
需要技术支持或样品?
请提供您的基材规格、印刷机参数和故障照片,我们杭州应用工程师将在1个工作日内给出针对性建议并安排实验室样品。
发送技术咨询 申请样品常见问题
为什么长跑才起泡?
消泡剂持续消耗,机械带入空气累积。回液管浸底+按比例补加通常解决。
能多加消泡剂快速消泡吗?
不能。过量消泡剂会引起鱼眼、缩孔和层间附着力下降。
针孔都是泡沫引起的吗?
不是。针孔也可能来自基材润湿不良、网穴脏污或油墨污染。